Cardinal Detecto Dokumentacja Pobierz pdf (Strona 5)

COMPONENTS AND CONTROLS (cont.)

Leveled

Not leveled

Shipping thumb

screw(located on

bottom of scale)

REMOVE ALL SHIPPING SCREWS

BEFORE USING SCALE, TWO

SCREWS FROM TOP AND THUMB

SCREW FROM BASE.

8529-B222-08 REV.A

Turn the top two (2)

shipping screws

counter-clockwise to

remove.

2. PLACEMENT

Place the scale on a stable,

vibration-free location away from

direct sunlight and away from any

rapid moving air source. Make

certain the power cord is stored

out of the way of normal traffic.

CAUTION!!! DO NOT

place the scale on

any unstable cart,

stand or table. The

scale may fall, causing injury to

the operator, and seriously

damage the unit; or proper

operation of the scale may be

inhibited.

3. LEVEL SCALE

Before mounting the commodity tray onto the scale, level the scale if necessary by adjusting the

four legs on scale bottom, up or down, until the bubble in the level gage located on the scale

housing is centered as shown in the figure above. After level is achieved, lock legs in place by

tightening lock nuts on legs against the scale bottom.

POWER SUPPLY

1. Plug power supply into a wall receptacle that supplies 115 VAC power and into the connector on

the underside of the chassis.

2. On models requiring 230 VAC power, use the Cardinal/Detecto model 8529-B216-08, 230 VAC

power supply. After installation of the proper connection, plug scale power supply into 230 VAC

receptacle.

CAUTION!!! - To avoid electrical hazard and severe damage to the scale, use only

the wall-plug-in power module provided with the scale.

3. START-UP - The scale is equipped with ON and OFF keys on the keypad. When the ON key is

pushed, the scale will show zero weight, signalling that the scale is ready for use. If the deadload

on the scale is not within ± 4% of the deadload used during calibration, the scale will display LoAd

or UnLoAd, indicating that weight must be added or removed, respectively, from the platform. Once

the deadload is within ± 4% of the deadload used during calibration, the scale will zero and is ready

for use.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag

Cardinal Detecto Dokumentacja Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Wagi kuchenne Cardinal Detecto